This guide also applies to the Endgame Buttons for Miyoo. The disassembly is the same, just install the face buttons when you have accessed them.

<aside> 🗒️

Note on Versions

The version number, like “V1” or “v1.1” on the bottom of the DPad just is for tracking process changes for the DPad itself and does not match the console versions.

</aside>

Materials

• Miyoo Mini Plus
• Better DPad
• PCB Protector Sticker
• Lubricating Oil Swab
• Plastic Pick
• Small Philips Screwdriver

Procedure

Disassemble console

1. Open battery cover and pry out the battery. There will be a wire attaching it to the circuit board.

1. Carefully unplug the battery and put aside.

1. Unscrew the 6 screws on the back shell of the console. Set screws aside.

1. The back shell in held on by a few internal clips. Their locations are highlighted in the diagram. Use the pick to separate the two halves of the shell and undo these clips.

1. Remove power and volume buttons so they don’t get lost and side aside.

1. Unscrew the two screws holding the circuit board in the front shell.

1. Unplug the display ribbon cable. You must unlock it first
   1. Flip up the black lever on the connector
   2. With the lever up, the ribbon cable should pull out easily

1. Take the circuit board out of the front shell. You will still need both the circuit board and the front shell for future steps.